Bearing Suffixes C
Bearing Suffixes: A - B :: C :: D - F :: G - K :: L - N :: P - S :: T - Z
C |
|
CA |
|
CAC | Spherical roller bearing of CA design but with enhanced roller guidance |
CB |
|
| |
Single row angular contact ball bearing, optimized internal design, 15° contact angle | |
Tapered roller bearing with tolerances corresponding to ISO tolerance class 6X | |
Inch tapered roller bearing with tolerances to class 0 according to ANSI-ABMA Standard 19.2:1994 | |
Inch tapered roller bearing with tolerances to class 00 according to ANSI-ABMA Standard 19.2:1994 | |
Inch tapered roller bearing with tolerances to class 3 according to ANSI-ABMA Standard 19.2:1994 | |
Tapered roller bearing with special frictional behavior and heightened running accuracy | |
Normal internal clearance, normally only used together with an additional letter that identifies a reduced or displaced clearance range Examples:
| |
Full complement cylindrical roller bearing with modified internal design | |
Sheet steel reinforced contact seal of Acrylonitrile-Butadiene rubber (NBR) on one side of the bearing | |
CS contact seal on both sides of the bearing | |
Sheet steel reinforced contact seal of fluoro rubber (FKM) on one side of the bearing | |
CS2 contact seal on both sides of the bearing | |
Sheet steel reinforced contact seal of hydrogenated Acrylonitrile-Butadiene rubber (HNBR) on one side of the bearing | |
CS5 contact seal on both sides of the bearing | |
Bearing internal clearance smaller than C2 | |
Bearing internal clearance smaller than Normal | |
Bearing internal clearance greater than Normal | |
Bearing internal clearance greater than C3 | |
Bearing internal clearance greater than C4 | |
Reduced tolerance for running accuracy of inner ring of assembled bearing | |
Reduced tolerance for running accuracy of outer ring of assembled bearing | |
C02 + C04 | |
C02 + C04 + C3 | |
Reduced tolerance for the bore and outside diameters |